b2btochina

The use of the motorcycle, some maintenance is the user that they can do. This is to reduce the trouble to repair shop, they can save time, can help increase your understanding of the motorcycle.
Spark Plug Maintenance
Motorcycle engine spark plug is a key component. Normal combustion of the mixture is the key to the normal operation of the engine. First of all, the spark plug for each engine model used is different, mainly heat value, the different thread size, so be sure to use the model provided the spark plug. Normal combustion engine, unscrew the spark plug observed, the electrode should be a rich red normal, if the black, that is, carbon deposition, indicating that the mixture too thick, inadequate combustion, should clean up carbon deposits. The central electrode with a tip clearance groove and L-polar carbon; adjust spark plug gap: GS125 (0.6-0.9mm), QS150T (0.7-0.8mm), the carbon would prevent a good spark plug spark and airbrush guns, and may be off the fire ; If it is found easy to wet or burned spark plug gray, that does not match the spark plug heat value, you should specify the repair shop to replace the Suzuki suitable spark plug Note:
1 to determine the thread size and piston rod length. If the piston rod is too short, the threads in the plug holes caused by the Ministry of damage caused by carbon deposits and engine.
2, in the application before the spark plug wrench, spark plug can be carefully hand screw threads of the cylinder head department, to prevent damage.
3, the use of special vehicle tools spark plug socket, tighten the spark plug to the required tightening torque.
Air Filter Maintenance
Electric motorbike air filter is the respiratory system. If the air filter blocked by dust, air resistance will be larger and would decrease the engine power output, fuel consumption increases, but also make the engine difficult to start, easy to turn off, seriously, dust inside the cylinder will increase wear on engine parts . Clean air filter according to the following steps:
Remove the air filter cartridge from the car care;
If the filter is a sponge foam, neutral detergent solution can be carefully cleaned, do not wring, dry cleaning finished water, drop 2-3 drops of oil (for absorption of air in very fine dust), even with the hand, according to the status quo Replace; paper filter if it is, must not use liquid cleaning house dust may be forced knock out and conditional use compressed gas into the air by blowing the opposite direction (do not engage in counter, otherwise the dust will be blown into the paper core porosity more severe obstruction); cases: QS150T paper core blowing from the inside out, from the outer ring to the Prince storm blowing in the hole.
Replace the filter installation should pay attention to the direction of orientation and intake;
With dust, dirty environment, traffic, should increase the cleaning frequency was found broken or paper filter soaked sponge to immediately replace the new, otherwise it will damage the skid steer loader or black smoke.
Maintenance of the oil filter
Most users know that should replace the oil, but to grasp the principle:
Is the replacement of a new oil filter is not replaced is not acceptable. Engine lubrication process, the oil pump to suck out the oil tank from the bottom, first pressed into the oil filter filter, filter oil and then transport the clean end to the cylinder head, crankshaft and transmission parts. If too dirty filter, oil filter less effective, reducing the amount of output of oil, lubricating parts are not good, it will cause excessive wear and tear, only the weight-for-oil is not enough, you must also replace the oil filter .